Removing The Top Cover - HP D5970A - NetServer - LCII Guía Del Usuario

Chapter 2

Removing the Top Cover

To remove the top cover, follow these steps:
NOTE
You do not need to removal the front bezel to remove the top
cover of the Netserver.
1. If the HP Netserver is operating, log off all users and shutdown the
operating system.
Refer to the instructions in Chapter 1, "Controls, Ports, and Indicators."
2. Disconnect the power cord and any cables attached to the Netserver.
3. Remove the Netserver chassis from the rack and lay it on a flat surface.
Refer to the instructions in Chapters 7, 8, or 13 (depending on the rack
type) to remove the chassis from the rack.
NOTE
Some rack mounting options (slides) do not require removing
the HP Netserver chassis from the rack and laying it on a flat
surface to access the internal components.
4. Release the top cover by turning the knob at the front of the chassis to
"Open" position (clockwise direction). See Figure 2-2.
5. Slide the top cover about 1½ inch (38 mm) toward the front of the
Netserver and then lift it off the chassis.
Opening and Closing the HP Netserver
11