HP D5970A - NetServer - LCII User Manual page 23

Chapter 3
Installing the Application Files onto the Network
To install the HP NetServer Information Assistant onto the network, perform
the following steps:
1. Run Windows as you normally would, and display the Program Manager.
2. Insert the HP NetServer Information Assistant CD-ROM into the
CD-ROM drive.
3. From Program Manager, select the File menu and choose Run.
4. At the command prompt, type the following:
{drive}:\infoasst\setup /a
where {drive} is the letter of the CD-ROM drive.
5. Follow the instructions that appear on your screen.
Running the Setup Program on a Client PC
To run the HP NetServer Information Assistant from a client PC, it is necessary
for the client to run the setup program that was installed onto the network hard
disk, as follows:
1. Run Windows and display the Program Manager.
2. From Program Manager, select the File menu and choose Run.
3. At he command prompt, type the network location where the HP
NetServer Information Assistant files were installed, followed by setup.
For example, if Information Assistant was installed on drive
"N:\windows\iaclient," you would enter the following:
N:\windows\iaclient\setup
4. Follow the instructions that appear on your screen.
HP NetServer Information Assistant
17