HP D7171A - NetServer - LPr Manual page 57

Chapter 3
WARNING
Before sliding the HP NetServer LH 6000r out of the rack,
make sure you extend the anti-tip foot from under the front of
the rack.
A tip-over hazard exists, so never slide more than one
component out of the rack at a time.
NOTE
Do not remove the screws that hold the slides to the front
columns of the rack. Slide the NetServer out by grasping the
handle below the LCD control panel.
3. Remove the front bezel and extend the anti-tip foot. Fully extend the
NetServer (until it clicks) to determine the length of the cable loop. See
Figure 3-11. Cycle the server in and out of the rack to see whether hook-
and-loop straps are required to secure the cables in the cable arm. If so,
place them at regular intervals along the arm.
Figure 3-11. Extend the Server to Adjust Cable Lengths
4. Loop extra lengths of cable and tie-wrap it alongside the NetServer. Use
Cable Guides on the column of the rack to route cables to their
destinations.
Procedure for Connecting and Routing Cables to the LH 6000r
To PCI
Cards
Extend the Cable Management Arm
to ensure you have enough cable
before routing cables through the
Cable Guide.
53