HP D7171A - NetServer - LPr Configuration Manual page 4

SPU
Model
Clock speed
No. of CPUs
BIOS version
CPU cache
RAM
No. of power supplies
Hot swap cages
Local storage
I/O slots:
Storage
Local
Physical drive location
Disk drives
Cables
Controller
Shared
Controller
Model
No. of controllers
Firmware
Driver
NetRAID Assistant
SPU I/O slot
SCSI ID
Channels
RAID level
Logical disks
Configuration
options:
HP NetServer LH Pro 6/200 Model 1
200 MHz
2 (at least two are required)
4.05.14 PF or later
Any size
128 MB minimum. Must be HP.
2
May use for local storage; but not use for shared storage.
Internal or external, using any controller. Must use HP disks. See
Storage below.
P9 - Shared storage controller (P8 if using NetRAID for local storage.)
P7 - Intra-cluster (Heartbeat) LAN
P6 - Client LAN
All others - Any other plug-in cards.
SPU internal drive bays, or HP external drive cabinet (e.g., HP Storage
System/6), or any combination.
Must be HP
Must be HP and < 3 m total length for external drive cabinet.
SPU embedded controller or any controller (any number, manufacturer or
driver) in any available I/O slot. Use P9 for NetRAID local storage. See
SPU I/O slots above.
HP NetRAID D4943A
Use with HP Storage System/6 and HP Cluster Adapter only.
1 maximum
S.01.00
2.03
A.01.09
P9 (P8 if using NetRAID for local storage.)
6, 7
0 and 1 only
Do not use channel 2 for any purpose.
1, 5, 10, and 50 only
1 per RAID array
6 maximum per NetRAID adapter
Cluster mode on (cache write-through, no hot spare)
Ultra SCSI disabled
Termination: wide channel or automatic
Set any other options as you prefer
2
Local