Removing The Hp Netserver's Top Cover And Pedestal - HP D7171A - NetServer - LPr Installation Manual

Chapter 2
Removing the HP NetServer's Top Cover and
Pedestal
Use this procedure to remove the bezel, top cover, and pedestal from the pedestal
version of the HP NetServer LC 2000.
WARNING
Do not operate the HP NetServer with its covers removed.
Always disconnect the power cord before removing any
covers, to avoid exposure to high energy levels that may cause
burns when parts are short-circuited by metal objects such as
tools or jewelry. Disconnect any telephone cables to avoid
exposure to shock hazard from telephone ringing voltages.
CAUTION To prevent overheating, never operate the NetServer with its
cover removed. This includes the power supplies and Hot
Swap hard disks, which must be replaced or the opening
covered immediately (within 2 minutes).
1. If the HP NetServer is operating, log off all users and if necessary back-up
files.
2. Follow instructions in your network operating system (NOS)
documentation to gracefully shut down all networking software and
applications.
3. Press the power switch on the HP NetServer's control panel when
prompted by the operating system.
Normally, this completes the power down procedure.
4. Disconnect the power cord from its power source.
6
Prepare the HP NetServer for Rack-Mounting