Preparing The Rack; Hp Netserver Rack Mount Parts List; Marking The Rack And Attaching Rack Nuts - HP D7171A - NetServer - LPr Installation Manual

Chapter 3

Preparing the Rack

The column adapters and cage nuts must be connected to the rack before
mounting the slide mechanism. Once the slides are correctly mounted, then the
HP NetServer LC 2000r can be installing into the rack.

HP NetServer Rack Mount Parts List

Ensure the rack-mounting kit provided with the HP NetServer and the non-HP
rack mount kit contain the following parts.
Table 2-1. Parts for Rack Mount Kit
Quantity
2 Slides
4 Washers
6 M6x16 Cage Nuts
8 Cage Nut Screws (M5 x 16mm)
6 Screws for Slides (8-32 x ¼ inch, 4 panhead and 2
flathead)
2 Column Adapters
Marking the Rack and Attaching Cage Nuts
Use this section to mark the front columns and attach the cage nuts to the rear
columns of the Compaq 4000- or 7000-series rack. The column adapters attach to
the front columns and the slides are attached to the column adapters and the cage
nuts to hold the NetServer's slides in place. Use the marking pen to mark the
locations on the columns.
CAUTION
If other rack components are to be mounted in the rack below
the HP NetServer, install those components before starting to
mount the NetServer.
NOTE
Use the HP Rack Configuration Tools to determine where in
the rack to mount the HP NetServer. The tools are available at:
http: //www.hp.com/netserver/support
Rack-Mounting the HP NetServer
Description
13