4. PREPARATION BEFORE SEWING
4-1. Installing the needle
Turn off the power switch before installing the needle, otherwise the machine may operate if the foot switch is depressed
by mistake, which could result in injury.
4-2. Threading the upper thread
Thread the upper thread correctly as shown in the illustration below.
* When using threading mode for threading, the tension discs (1) will open so that the thread can be threaded more easily. (Refer
to following page.)
[When using the needle cooler (option)]
Approx. 40mm
CAUTION
1. Loosen the set screw (1).
2. Insert the needle (2) in a straight line as far as it will go,
making sure that the long groove on the needle is at the
front, and then securely tighten the screw (1).
2300B
KE-430F, BE-438F
4. PREPARATION BEFORE SEWING
[Two holes]
Synthetic thread
Spun rayon yarn
[One hole]
2301B
26