HP LC2000r - NetServer - 128 MB RAM User Manual page 59

Chapter 8
Type 1--Mounting the Slides
Once you have marked the locations of the slides, attach them. To do so for the
"Type 1" Rack, follow these steps :
First, orient the slides so the slide members extend out the front
of the rack.
Insert screws through the rack column and start them in one bar nut at
the correct location on each column (see Figure 8-5). Prepare to insert
the mounting flange of the slides between the column and the bar nut.
(Refer to Figure 8-6.)
Then line up the front and rear mounting flanges of the slide with the
screws started in the bar nuts. Press the slide firmly against the rack
column. See Figure 8-8.
Tighten all four screws in the mounting flanges of each slide.
Mounting
Flange
Figure 8-8. Orientation and Fastening of Type 1 Slides
Mounting the NetServer in a Rack
For Type 1 rack, insert
screws through all four rack
columns and start them in bar nuts.
Then insert the
mounting flange
in place on
each column and
tighten the screws.
51