Netware Driver Loading; Overview; Driver Loading On An Existing Netware Server - HP LC2000r - NetServer - 128 MB RAM Manual

Fibre channel host bus adapter

Hide thumbs Also See for LC2000r - NetServer - 128 MB RAM:

Table of Contents

NetWare Driver Loading

NOTE

Check this worldwide web address to ensure that you have the latest

version of the NetWare driver:

http://netserver.hp.com/netserver/

If it is a newer version than the one on the supplied HP Navigator CD,

download it and use it instead of the earlier version.

Before loading the HP NetWare Fibre Channel Adapter driver, verify that the

programs "NWPA.NLM" and "SCSIHD.CDM" are loaded on your system. In

most cases, these programs exist on your system if it is running NetWare 5.

The HP Navigator CD contains the fibre channel HBA drivers.

• You need to create a driver diskette before driver installation. Follow

these procedures to create driver diskette:

• Insert the HP Navigator CD into the HP Netserver CD-ROM and boot

the Netserver with the CD.

• On the main menu, select Netserver utilities, then select diskette

library.

• Select the "HP D8602B Fibre Channel HBA NetWare 5.x support

disk".

• Insert a diskette into the floppy disk drive.

• Follow instructions on the screen to create driver diskette.

To install the driver, perform the following steps:

1. Insert the HP Fibre Channel Driver Diskette for Novell NetWare 5.x into the

floppy drive.

Table of Contents