HP LC2000r - NetServer - 128 MB RAM Manual page 24

NOTE The driver can either be installed from the hard drive or floppy
diskette. For driver installation from the hard drive, copy the driver
file to the server boot up directory under DOS, and specify the
complete device path when typing the instruction below. For
installation from the floppy diskette, continue with instructions as
specified below.
2. Switch to the Command Console and type:
LOAD A: \AFCNW.HAM <RETURN>
The driver starts loading, and the display shows the slot number that the
Adapter is in.
If there are multiple HP Adapters installed in the system, the driver will prompt
you with a list of slot numbers to select the appropriate controller. The driver
must be loaded for each controller card added to the system configuration.
3. Remove the floppy diskette after the driver loads. The drives are now ready
to be configured using the normal network administrator access to create
volumes and/or partition the drives. The startup.ncf file can be modified to
load the driver automatically whenever the server is rebooted.
18