Table of Contents
Advertisement
Adding channels to the TV's memory
When you press Channel y or z, your TV will stop only on the
channels you program into the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them into its memory. After the channels are programmed
automatically, you can manually add or erase individual channels (see
page 30).
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z until TV/CABLE is highlighted, and then press
ENTER to display the pull-down menu.
3. Press y or z to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable channels, highlight CABLE.
LANGUAGE
ANT 1 / 2
TV / CABLE
CH PROGRAM
ADD / ERASE
:
S E L E C T
4. Press ENTER.
5. Press z to select CH PROGRAM.
LANGUAGE
ANT 1 / 2
TV / CABLE
CH PROGRAM
ADD / ERASE
:
MOVE
6. Press ENTER to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now—Please Wait" appears.
7. When channel programming is complete, the message
"Completed" appears.
8. Press Channel y or z to view the programmed channels.
Downloaded from
www.Manualslib.com
SET UP
T V
C A B L E
ENTER
: SET
SET UP
E N G L I S H
ANT1
CABLE
ADD
ENTER
: START
manuals search engine
Note:
To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
POWER
TV
LIGHT
SLEEP
CABLE/SAT
VCR
1
2
3
DVD
AUDIO1
AUDIO2
4
5
6
MODE
7
8
9
PIC SIZE
+10
0
100/
ENT
ACTION
MENU
MENU
FAV
ENTER
ENTER
yzx •
FAV
Channel yz
VOL
CH
EXIT
DVD CLEAR
DVD RTN
CH RTN
INPUT
RECALL
MUTE
SLOW/DIR
SKIP/SEARCH
E
F
S
29
Advertisement
Table of Contents
