Set The Ip Address Using Ping; Setting Example - Epson C32C824461 - UB R03 Print Server Technical Reference Manual

Set the IP Address using PING

Set the IP Address using the PING (ICMP Echo Request) command.
When setting the IP Address, take care not to overlap with the IP Address for using other
network equipment and the computer.
When the ʺSet using PINGʺ function is set to Enable, the IP Address can be set from the host in
the same segment to which the ARP command and the PING command are supported.(Refer to
ʺTCP/IP Settingʺ on page 64)
When an IP address is obtained with the Ping (ICMP Echo Request) command, the setting
changes below follow:
• Changes the IP address to the obtained value.
• Changes the value of the subnet mask according to the obtained IP address class.
• Uncheck the check box of "Set using PING."
• Changes the mode to obtain an IP address to "Manual assignment."
After the above changes are made, the printer is reset.

Setting example

This section explains the setting example for setting the IP Address to 192.168.192.168.
1
Set the gateway address to the computer for input ARP/PING
command.
When there are the server and the router for gateway, input the gateway address.
When there is no gateway, input the IP Address of your own computer to the gateway
address.
If the gateway is not known, inquire of the network administrator.
2
Connect the printer in which the UB-R03 has installed with the network,
turn on the printer.
The IP Address cannot be set unless the gateway has been set.
Chapter 3 Utilities
3
71