Brother 1660E Service Manual page 68

(7) Release the left hook and take off the paper delivery actuator.
Paper delivery actuator
(8)
1) Remove the fixing heat insulation cover ( by loosening the 2 screws), the pressure roller
spring and pressure roller bearing on both sides, and the pressure roller.
Pressure roller bearing
Pressure roller spring
Fixing unit chassis
2) Remove the retaining rings (on both sides).
3) Remove the HR gear, loosen the screw and remove the spring washer, remove the left and
right HR bearings and the heat roller by sliding it.
Retaining ring
HR bearing
Figure 4.52
Pressure roller
Figure 4.53
Screw
Spring washer
Figure 4.55
Fixing unit cover
Screws
Figure 4.54
Heat roller
HR bearing
IV - 21
Heat insulation cover
HR gear
Retaining ring