Operation; Line Inspection Mode Procedure - Brother 1660E Service Manual

6. OPERATION

6.1 Line Inspection Mode Procedure

(1) Mount the font cartridge, the flush memory card and the optional MIO board.
Note:
(2) While pressing the
The LCD will display:
(3) Press the
(4) Press the
All the LEDs will go out and the LCD will display the characters shown below:
Press all the switches by turns.
X X X X X X X X
1 2 3 4 5 6 7 8
(5) Press the
RAM SIZE =
RAM SIZE =
RAM SIZE ERROR
(6) Press the
FAN HIGH SPEED
Press the
FAN LOW SPEED
(7) Press the
TRAY 1 =
TRAY 1 =
TRAY 1 =
CASSETTE ERROR!!
(8) Press the
TRAY 2 =
TRAY 2 =
TRAY 2 =
CASSETTE ERROR!!
(9) Press the
MP TRAY
MP TRAY OK!!
Use a Hewlett Packard Company C2053A#C01 Word Perfect as font cartridge.
switch, turn the power on.
LINE TEST
SET switch to check if the LCD comes on.
CONTINUE switch to check the pushbutton switch.
CONTINUE switch to check RAM size.
8MB 8M (standard)
XXMB XX : SIMM capacity + 2M
In case of error
CONTINUE switch to check the fan.
Make sure that the fan rotates at the high speed.
CONTINUE switch.
Make sure that the fan rotates at the low speed.
CONTINUE switch to check the 1st stage cassette.
A4 Appears when the cassette is set to A4 size.
LETTER Appears when the cassette is set to letter size.
NO Appears when no cassette is set.
Appears in case of error.
CONTINUE switch to check the 2nd stage cassette.
A4 Appears when the cassette is set to A4 size.
LETTER Appears when the cassette is set to letter size.
NO Appears when no cassette is set.
Appears in case of error.
CONTINUE switch to check multi purpose tray.
Set paper on the MP tray.
All the LCD elements will come on
simultaneously.
1
VI - 23
Switch key numbers
2 3 4 5 6 7 8