Replacing The No. 2 Scoop-Up Sheet Assembly; Points To Note When Handling The Pre-Cleaning Sensor Assembly; Pre-Cleaning Sensor Assembly No. 2 Scoop-Up Sheet Assembly - Canon CLC 1120 Service Manual

5) Remove the screw [5] (one each), and
remove the end felt [6].
G. Pre-Cleaning Sensor
Assembly No. 2 Scoop-Up
Sheet Assembly
1. Replacing the No. 2 Scoop-Up
Sheet Assembly
1) Remove the
assembly.
2) Remove the screw [1], and detach the pre-
cleaning sensor [2].
3) Mount the pre-cleaning sensor to the new
No. 2 scoop-up sheet plate.
4) Mount the pre-cleaning sensor assembly
to the copier.
2. Points to Note When Handling the
Pre-Cleaning Sensor Assembly
If you have removed or replaced the pre-
cleaning sensor assembly, be sure to perform
the following:
1) Dry wipe the window of the pre-cleaning
sensor, and mount it.
2) Turn on the power switch so that the copier
will be in standby state.
3) Select and execute FUNCTION>SENS-
ADJ>CLN-OFST.
4) Record the value of ADJUST>SENS-
ADJ>CLN-TH, CLN-TMP on the service
label behind the right front door.
COPYRIGHT © 1999 CANON INC.
pre-cleaning sensor
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 IMAGE FORMATION SYSTEM
[6]
[5]
Figure 6-672
[1]
Figure 6-673
[6]
[5]
[2]
[1]
6-81