Table of Contents
Advertisement
Installing the plasma display on the angle adjustment unit
To fasten the plasma display to the ceiling mount unit, engage the four pins of the angle adjustment unit in the
four cutouts of the display mount fitting on the back of the plasma display. Next, tighten the two screws from the
bottom.
When installation is complete, fasten the wiring cable with cable clamps as necessary.
Make sure that
the pins and
cutouts at both
the top and
bottom are
.
firmly engaged
Cutout
Display mount fitting
M6
X
- 9 -
Pin
Angle adjustment unit
The plasma display
should always be
Cable
carried by at least
clamp
two persons.
Disconnect all of the
plasma display
power cords and
cables.
Make sure that the
angle adjustment unit
holes and display
mount fitting screw
holes are aligned
18 screw
before tightening the
screws.
Advertisement
Table of Contents
