Scsi Id Setting; Figure 5.3 Cn2 Setting Terminal (On Np Models Only) - Fujitsu MBA3073NC - Enterprise 73.5 GB Hard Drive Product Manual

2
1
5.3.1
76
Downloaded from www.Manualslib.com
4 6 8 10 12 14 16
3 5 7 9 11 13 15
Figure 5.3

SCSI ID setting

Table 5.1 shows the SCSI ID setting. For the terminal location and allocation of NC model, see
Figure 4.13 and Table B.1. For NP model, see Figure 5.2 and 5.3.
When the SCSI ID is set using the external operator panel connector
CN1 of NP model, all pins listed in Table 5.1 should be open. If any
of pins are shorted, unexpected SCSI ID is set.
manuals search engine
18 20 22 24
17 19 21 23
Terminator power supply: Supply
(LED signal)
(HDD Reset signal)
N.C.
Force Single Ended: LVD mode
Force Narrow: 16-bit SCSI
Motor start mode
Write protect: enabled
SCSI ID #15
CN2 setting terminal (on NP models only)
IMPORTANT
C141-E270