5.3.3
80
Downloaded from
www.Manualslib.com
Mode settings
In addition to the previously described settings using setting terminals, the HDD is provided with
several mode settings. The mode settings are enabled by specifying the CHANGE DEFINITION
command. Table 5.7 lists the mode settings and their settings at factory shipment.
Refer to Subsection 3.1.4 "CHANGE DEFINITION (40)" of the SCSI Logical Interface
Specifications for details of the CHANGE DEFINITION command.
Table 5.7
Default mode settings (by CHANGE DEFINITION command)
Mode setting
SCSI level
SYNCHRONOUS DATA TRANSFER REQUEST message
sending
UNIT ATTENTION report mode
Reselection retry count
WIDE DATA TRANSFER REQUEST message sending
Reselection time-out delay
Spindle motor start delay time
manuals search engine
Contents
SCSI-3
Not sent from HDD
Reported
Not restricted
Not sent from HDD
250 ms
0 sec (NP)
12 sec × SCSI ID (NC)
C141-E270