Table of Contents
Advertisement
4
To move the player, press the power button on the
player to power it off, and disconnect it from the
network.
5
Repeat the steps from "Connections" on page 8 for all
other players.
For the second player and later, click [Detect VSP-
NS7s] to start automatic player detection, after you
connect the player to the network.
Then, install the players in their actual operating
locations, and continue setup operations.
See "Installation" on page 11 for details on
installation of the players, and "Settings Required
After Installation" on page 12 for details on the setup
operations after installation.
If a player is not detected in automatic
player detection
If communication using the UDP2380 port is not allowed
on the network between the VSPA-D7 software running on
a computer and a player, the player will not be detected in
the automatic player detection process. In such a case,
connect the computer and the player using either of the
following two methods, and retry the procedures described
in "Setting the network address" on page 8 and
"Registering the player with the VSPA-D7 software" on
page 9.
Notes
• Connect a display device to the
player using an RGB cable to set up the player.
• If a message asking whether you would like to start
automatic player detection does not appear when you
click the
Setup" window, click [Detect VSP-NS7s] in the
window.
To connect the player and computer directly
Player
Network cable (cross cable)
10
Settings Required Before Installation
connector of the
button to open the "VSP-NS7
Computer
To connect the player and computer via a
switching hub
Player
Switching hub
Network cable
(straight cable)
Note
When connecting multiple players in turn to perform the
setup, some switching hubs may not recognize a connected
player. If this happens, turn the power of the hub off once
and then turn the power on again.
Computer
Network cable
(straight cable)
Advertisement
Table of Contents
