Settings Required Before Installation; Internet Explorer Settings - Sony VSP-NS7 Setup Instructions

Note
An automatic player detection function is supported to set
IP addresses for the players and to register the players with
the VSPA-D7 software. Note that, if the players will be
connected to a different network (segment) from that of the
computer where the VSPA-D7 software is operating, this
function must be used before moving the players to their
actual operating locations.
Player settings
After installing the players in their actual operating
locations, you can adjust the volume, and set the time zone
and daylight saving time of the installation location, using
the "VSP-NS7 Setup" window.
When you use a display device that is controlled via a
network, it is also registered and assigned to the player that
controls it in this window.
Then, you can set data related to the player by sending the
data from this window to the player.
Other settings
You can make the settings shown in gray in "Flow of
Installation and Setup Operations" even after starting
system operation.
For details about these setup operations, refer to the
VSPA-D7 Operating Instructions.
Each setup window corresponds to one of the operation
guide buttons on the left side of the VSPA-D7 main
window. You can add or change these settings even after
starting operation. If the buttons for the setup windows are
not displayed, click
Settings Required Before
Installation

Internet Explorer Settings

During communication with a player, both the VSPA-D7
and VSPA-M7 software use the web browser (Internet
Explorer) settings. Set the following two items.
• Connecting the computer to the Internet using a LAN
• Make the setting that indicates a proxy server is not to be
The illustrations used in the following steps are those of
Internet Explorer Version 7.0. The procedure is the same
even if you are using another version of Internet Explorer.
1
2
3
to display them.
4
5
used for communication with the players
Note
Start the web browser (Internet Explorer).
The Internet Explorer window appears.
Click [Tools] on the menu bar, then click [Internet
Options] from the pull down menu.
The "Internet Options" window appears.
Click the "Connections" tab.
The following window appears.
Click [Connections].
Click [LAN Settings].
The "Local Area Network (LAN) Settings" window
appears.
Make the following settings in the "Local Area
Network (LAN) Settings" window.

Settings Required Before Installation

5