Removing The Power Supply Shield Plate; Removing The Power Supply Assembly; Removing The Manual Pickup Solenoid - Canon MF3110 - ImageCLASS Laser Multifunction Service Manual

3.5.5.11 Removing the Power
Supply Shield Plate
1) Remove the 5 screws [1] to remove the power
supply shield plate [2].
[2]
[1]
[1]
F-3-219
3.5.5.12 Removing the Power
Supply Assembly
1) Remove the 3 screws [1].
2) Remove the 4 connectors [2] as well as the flat
cable [3] on the ECNT board.
[1]
[2]
[2]
F-3-220
0007-7869
0007-7870
[3]
[1]
3) As you remove the bosses on both sides [1], lower
the front part of the power supply assembly [2].
Then pull it to remove the power supply assembly.
[2]
[1]
F-3-221
3.5.5.13 Removing the Manual
Pickup Solenoid
1) Place the main unit down on its front face (so that
the interior of the main unit is easily visible).
2) Remove the cable [1] from the cable guide.
3) Remove the screw [2] to remove the manual pickup
solenoid [3].
[1]
[3]
[2]
F-3-222
Chapter 3
0007-7871
3-55