Chapter 3
3.1.9.4
Removing the rear
cover
1) Opening the face up cover [1], and then lower the
fixing pressure release levers [2] on both sides and
release the pressure.
2) Remove 2 screws [3].
3) Remove the rear cover [4] as you pull it toward you.
[2]
[3]
[1]
F-3-47
3.1.9.5 Removing the Power
Supply Shield Plate
1) Remove the connector [1] and remove the cable
from the cable guide.
[1]
F-3-48
3-12
0007-7570
[3]
[4]
0007-7694
2) Remove the 9 screws [1] to remove the power
supply shield plate [2].
[2]
[1]
[1]
F-3-49
3.1.9.6 Removing the Power
Supply Assembly
1) Remove the 3 screws [1]. (The external cover is
omitted from the illustration below to show the
instructions clearly.)
2) Remove the four connectors [2] as well as the flat
cable [3] on the ECNT board.
[1]
[2]
[2]
F-3-50
[1]
0007-7697
[3]
[1]