Cisco AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle Installation Manual page 48

Online Insertion and Removal of the CT3 Feature Card
Note
Loosen the two captive screws that secure the feature card to the chassis until each screw is free of the
Step 8
chassis. (See
Figure 4-4
Figure 4-5
Grasp the feature card handle with one hand. Pull the card toward you until the card slides free of the
Step 9
chassis. Grasp the ventilated metal cover with your other hand to support and guide the feature card out
of the slot. (See
Caution Avoid touching any pins or circuit board components when you remove or install a feature card.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
4-4
The OIR procedure for the CT3 feature card is similar to that for the T1 or E1 feature card. See
the "Online Insertion and Removal Example for the T1 or E1 Feature Card" section on page 3-6
for an example of the output during OIR of an E1 feature card.
Figure 4-4 and Figure
Loosening the Captive Screws on the Cisco AS5350XM Universal Gateway
Captive
DFC
Captive
screw
screw
Loosening the Captive Screws on the Cisco AS5400XM Universal Gateway
Captive
Captive
screw
screw
Figure 4-6 and Figure
4-5.)
Carrier
card
4-7.)
Chapter 4 Channelized T3 Feature Card
Chassis
78-17406-01