Cisco AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle Installation Manual page 66

Online Insertion and Removal of the Voice Feature Card
Figure 6-2
Figure 6-3
Step 2 Initialize the software busyout procedure by entering the busyout command:
Router# busyout slot-number
Step 3 Check busyout status for the slot, by entering the show busyout command.
Router# show busyout slot-number
You can use the clear voice dsp command to immediately disable active calls on the voice feature card.
Timesaver
Verify that the OK/MAINT LED is off; this indicates that the feature card is offline and ready to be
Step 4
removed.
Note
Step 5 Attach an ESD-preventive wrist strap.
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
Loosen the two captive screws that secure the feature card to the chassis until each screw is free of the
Step 6
chassis. (See
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
6-4
Slot Numbering on the Cisco AS5350XM Chassis
Slot 0
Slot 2
Slot Numbering on the Cisco AS5400XM Chassis
Slot 0 Slot 1
Slot 2 Slot 3
Slot 4
Slot 6
The OK/MAINT LED is green before you enter the busyout command. After you enter the
busyout command, the LED changes to yellow. The LED turns off after all calls are
disconnected and resources taken out of service, indicating that busyout is complete.
Figure 6-4 and Figure
Slot 1
Slot 3
Slot 5
Slot 7
6-5.)
Chapter 6 Voice Feature Card
78-17406-01