Table of Contents
Advertisement
Automatic
Heat Sensor
Your hood is equipped
with an automatic
thermostat.
This thermostat
is a device that will turn on or speed
up the blower if it senses excessive
heat above the
cooking surface.
If your blower is not on, or if it is running at low speed,
the thermostat will sense excessive cooking heat,
override the norn-lal blower control and turn the blower
on to high speed. _l_e blower will run until the
temperature drops to norms
operating level. The blower
will then automatically
return to its original setting.
CARE AND CLEANING
WARNING:
ALWAYS
DISCONNECT
ELECTRIC
POWER
SUPPLY
BEFORE
SERVICING
HOOD.
Use a mild detm_ent
suitable for painted
surfaces.
DO NOT USE ABRASIVE
CLOTH,
STEEL WOOL
PADS, OR SCOURING
POWDERS.
Vacuum the
blower to clean it. Do not immerse the blower in water.
The glass visor assembly
and light lens are easily
removable
for cleaning:
DO NOT clean in a dishwasher.
Remove the light lens by opening
the filter panel and
turning the 2 metal clips holding
the lens in place.
Filter
Slide the glass visor open.
Open the filter panel
by turning the two clips and
allowing
it to swing free.
Flex the filter in the middle
to remove it.
Panelclip
Wash and rinse the filter in a
mild detergent
solution.
Replace the filter before using the exhaust fan.
Glass visor
Filter panel /
Grasp filter
remove
Light Bulb Replacement
This hood uses a 24" long F20TI 2 fluorescent
tube and an FS-2 starter, which are available
at
most hardware
stores or home centers.
To check or replace tube:
1. Pull the drawer out.
2. Rotate the filter panel clips and lower the
filter panel.
If the tube flickers or does not light, check the prongs
on the ends of the tube to make sure they are properly
seated in the tube holders.
If the tube continues
to flicker or does not light,
replace the tube. Slide the tube into the holders
and
rotate the tube so that the prongs in the holders grip
the tube and hold it in place.
If the ends of the tube light but the center does not,
the starter may require replacement.
The starter is
located behind the filter panel on the right hand side.
Install the new starter by pushing
the starter in and
turning it clockwise.
Stainless Steel
(on some models)
Clean with warm sudsy water, a stainless
steel cleaner
such as Kleen King ®,or an all-purpose
liquid or spray
cleanec Always
scrub in the direction
of the grain.
Rinse thoroughly
with a sponge or cloth and clean
water. Dry with a soft, clean cloth.
Do not use a soap-filled
steel wool pad; it will scratch
the surface.
3
Advertisement
Table of Contents
