GE 30" Vented Hood Use And Care & Installation Manual page 6

#8-18 x 2"
OR
#8-18 x 1"
BOX
INSERT
SCREWS
HERE
FRONT
_HOLE
BRACKET
Insert two (2) screws, short or long as appropriate,
through the control box and into the other mounting
bracket. Do not tighten the screws completely.
8. Secure the hood to the cabinet.
+++
Align the hood with the sides and front edge of the
cabinet. Tighten the screws in each mounting bracket.
Place plastic caps (provided) over the ends of these
screws from the inside of the cabinet.
Install two (2) additional screws into the cabinet
bottom, through the front mounting holes along the
front edge of the hood.
9. Replace the access cover.
Secure the access cover with the two (2) screws
removed in step 5.
10. Mount the cabinet on the wall.
Make sure the cabinet is securely attached to the wall
and/or adjoining cabinets. The mounted cabinet must
be able to support the added weight of the hood.
11. Attach the ductwork and the front trim.
#8-18x 318" j 1[/ +_ =_ -- -- FRONT TRIM
3-1/4" x 10" ,,_
DUCTWORK L,_,
Complete the ductwork from the hood to the outside
using a roof cap or elbow and wall cap. Tape all joints.
Shelves may be installed if trimmed to clear the
ductwork.
The front trim piece covers the gap between the
housing and the front edge of the cabinet cut-out.
Mount the front trim to the housing with two (2)
screws (provided).
6
12. Connect the electrical wiring.
!U W,RE
BOX
Remove the wire box cover. Attach the power cable to
the hood using the proper connector. Connect black to
black, white to white and green or bare wire to ground
screw. Replace the wire box cover.
CAUTION: DO NOT TURN THE BREAKER
ON OR INSERT THE HOUSE FUSE AT
THIS TIME.
13. Install the glass visor assembly.
_CONTROL
VISOR 7 TRIM
TRIM
THUMB
SCREWS
VISOR
SLIDE
Slide the glass into the visor slides, above each visor
damp (see the illustration in step 14). Align the visor
trim and tighten the thumb screws to secure the glass.
To remove the glass visor:
Simply loosen the thumb screws and pull the glass
from the visor slides.
14. Fine adjustments to the visor trim position.
VISOR
CLAMP
VERTICAL
ADJUSTMENT
SCREW
THUME
SCREWS
The visor slides each have a screw for adjusting the
height of the visor trim, if necessary. The vertical
adjustment screw allows the top and bottom edges of
the visor trim to be matched with the control trim.
15. Connect the power.
16. Check operation.