Installation Instructions - GE JGB928 Owner's Manual & Installation Instructions

Installation
Instructions
Range
In the Commonwealth
of Massachusetts
• This product must be installed by a licensed
phunber or gas fitter.
• When using ball type gas shut-off valves, they shall
be the T-handle type.
• A flexible gas connector, when used, must not
exceed 3 teet.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Installation of this rmage must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54,
latest edition. In Cmaada, installation must conform
with the current Natural Gas Installation Code,
CAN/CGA-B149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, mid with local codes where
applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest
edition and Cmladian Gas Association according
to CAN/CGA-1.1 latest edition.
As with any ai_plian{'e using gas and generating heat,
there are certain satiety precautions you should ti)llow.
You will find these
precautions
in the Important Safety
Information section in the front ot this manual. P,ead
them carefully.
• IMPORTANT - S ,,e these
instructions tot local electrical inspector's use.
• IMPORTANT - Obse,,e ,ll
governing codes and ordinances.
• Note to Installer
- i,eave these instructions
with the appliance after installation is completed.
• Note to Consumer
- Keep this Owner's
Manual and Installation Instructions for flmue
i'el[ei'en ce,
•
Note
- This appliance ulust be properly grounded,
•
Servicer
- The electrical diagram is in an envelope
attached to the back ot the range.
• Skill level - Installation of this appliance requires
basic mechanical skills.
• Proper installation is the responsibility of the
installer.
• Product faihu'e due to improper installation is not
covered under the _.Varrantv.
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or
other flammable vapors and liquids in the vicinity of
this or any other applim_ce.
If you smell gas:
Open windows.
O Don't touch electrical switches.
O Extinguish any open flame.
hmnediately call your gas SUl)plier.
TOOLS YOU WILL NEED
Phillipsscrewdriver
Flat-bladescrewdriver Open-endor
adjustablewrench
Pencilandruler __
Level
Pipewrenches(2)
(one for backup) Drill, awl or nail
MATERIALS YOU MAY NEED
• (;as line sh ut-off valve
• Pipe joint sealant or Ui,-ai)proved pipe thread tape
with Teflon':: that resists action of natural and I,P gases
• Nexible metal appliance connector (1/2" I.D.)
A 5-toot length is recommended tot ease ot installation
but other lengths are acceptable. Never use an old
connector when installing a new range.
• Flare union adapter
for connection
to gas suI)ply line
(3/4" or 1/2" NPT x 1/2" I.D.)
• Flare union adapter fl)r connection to pressure
regulator on range (1/2" NPT x 1/9" I.D.)
• I,iquid leak detector or soapy wateL
• I,ag bolt or l/2" O.D. sleeve alachor (fi)r concrete
flOOlS only).
*Teflon: Rcgistercd tl-,ldemarkof DuPont
39