Craftsman 113.22560 Owner's Manual page 7

GRINDING METAL
Move the workpiece across the belt.
If the workpiece becomes too hot to handle, quench it in
cold ware r.
Never push a sharp corner of the workpiece rapidly against
the belt because the belt could tear.
INSIDE WORK
WARNINIG: FOR YOUR OWN SAFETY, REMOVE PLUG
FROM POWER SOURCE OUTLET.
1. Remove both "Upper" and "Lower" guards.
2. Loosen wing nut and position guard back as shown.
3. Remove the "Hairpin Clip" which retains the rear idler,
Use a pair of long nose pliers.
4. Remove washer and idler, and position them on shaft
underneath table; replace clip.
5. Position belt over lower wheel and under idler, Thread
belt through opening in workpiece.
BELT ON
BOTH SIDES
OF PLATEN
BELT
IDLER AND PLATEN
&
HAIRPIN CLIP
/
6. Push down on arm and position belt around upper idler
and over upper wheel.
7. Make sure upper idler is positioned so that it causes belt
to run against platen,
8. tt can be adjusted by loosening nut "'A" and
repositioning idler arm.
9. Replace "Upper" and "Lower" guards.
10. Position guard back and tighten wing nut.
11. Follow same procedure for Sanding or Grinding.
7
NUT "A"
,o ) '!