Chapter 2 Setup; Setup Files - Fujitsu ETERNUS User Manual

Chapter 2
This chapter explains how to setup ETERNUSmgr.
Setup must be performed with administrator privilege.
2.1

Setup files

An ETERNUSmgr setup file is used to setup ETERNUSmgr to monitor a target device. The initial
setup files are generated automatically in the installation directory when ETERNUSmgr is
installed. See the "ETERNUSmgr Install Guide" of each OS for details of installing
ETERNUSmgr.
The parameters in each setup file must be adjusted to match the target device. After making the
necessary settings, shutdown and re-start the ETERNUSmgr to enable the new settings. Refer
to "Chapter 3 Startup and Shutdown" (page 39)
system.
It is recommended that you make a backup of the current setup files before making any changes.
Keep this backup until you have verified that the new setup files operate normally.
Setup file names must be in the following format:
STX-.INI
If the file name is other than as specified above, ETERNUSmgr will not be able to detect the file.
The only place setup files should be saved is the installation directory. If a setup file is saved in
another directory, ETERNUSmgr will not be able to find it.
The following setup file parameters must be set:
Target Address (See →
•
Target Type (See →
•
Target Flag (See →
•
Alarm History Files Directory (See →
•
The setup file parameters required will vary according to the operating system and target device
type.
The following list shows parameter types in the setup file and setting items for each OS.
P2X0-0202-04ENZ0 ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
Setup
You can edit only the setup file parameters described in this guide. Do not
delete comments or blank lines from any setup files, and do not add
anything other than parameters. Failure to follow these instructions may
hinder performance and/or cause problems during future upgrades.
page
page 20)
page 20)
for details on starting up and shutting down the
18)
page 24)
15
Copyright 2009 FUJITSU LIMITED