Fujitsu ETERNUS User Manual page 21

Chapter 2 Setup
> 2.3 Setting Items
[Example]
When the type of target device is ETERNUS2000:
TARGET_FLAG=4
Detect Offline Targets
This parameter determines whether or not notification is sent when a device goes offline.
The "Offline" condition is entered when ETERNUSmgr cannot monitor a target device due to a
machine problem (e.g. device is turned off, busy, etc.), or problem with the communication link
between the ETERNUSmgr server and the target device (e.g. bad connection, timeouts due to
network overload).
If this happens, the ETERNUSmgr Top Menu ("menu.htm") will show the target device status as
being "(*Offline*)" in a similar manner to the detection of machine failures, and E-mail notification
(if enabled) will be sent.
ETERNUSmgr does not provide for notification of "Offline" status if this parameter is omitted.
This parameter is enabled in its setup file immediately after installation.
Set "TRUE" to detect the offline status.
Omit setting to disable this parameter.
[Parameter]
DETECT_OFFLINE
[Example]
Detect the offline status, set as below:
DETECT_OFFLINE=TRUE
Busy Target Detection Time
This parameter is used to set the "target device busy" status detection time. Units are seconds.
Depending on what the ETERNUS device is doing, its device status can sometimes temporarily
become "busy".
In particular, the device cannot respond while it is booting.
Busy status is temporary, it does not mean device abnormality.
When device busy status is detected, ETERNUSmgr inhibits notification with logs or mails of
device abnormality for a set period of time.
When the busy status exceeds that definite period of time, ETERNUSmgr notifies of a device
abnormality.
[Default value]
1800 (seconds)
[Parameter]
BUSY_TIME (0-65535)
P2X0-0202-04ENZ0 ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
• The TARGET_FLAG parameter must be set to the correct Target Type.
ETERNUSmgr will be unable to monitor the target device properly if this
setting is wrong.
• Note that even if the TARGET_TYPE and the TARGET_FLAG settings
are different, ETERNUSmgr operations are not affected.
21
Copyright 2009 FUJITSU LIMITED