Fujitsu ETERNUS User Manual page 59

Chapter 6 Messages
> 6.4 Log Messages
Can't Get File Status "file name" (CODE 903)
Can't Create Socket (CODE 904)
Can't Allocate Memory (CODE 905)
Bad IP Address "host name or IP address" (CODE 906)
Can't Create Directory "path" (CODE 908)
Not NULL Parameter "parameter" (CODE 909)
Not Find Parameter "parameter" (CODE 910)
Parameter too long "parameter" (CODE 911)
Directory Name too long "directory name" (CODE 912)
Bad Parameter (CODE 913)
An example of log message output is shown below.
P2X0-0202-04ENZ0 ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
[Explanation]Cannot acquire file status.
[Response] Confirm your access permissions to the file and its directory.
[Explanation]Failed to create a socket.
[Response] Confirm system resources.
[Explanation]Failed to reserve an open area in memory.
[Response] Allocate the necessary memory.
[Explanation]The specified target IP address is invalid.
[Response] Set the correct IP address.
[Explanation]Failed to create a directory.
[Response] Confirm your access permissions to the directory.
Confirm that the name of the specified directory is correct.
[Explanation]NULL is not allowed for this parameter setting.
[Response] Set the parameter.
[Explanation]This parameter setting cannot be found.
[Response] Set the parameter.
[Explanation]Too many characters are used in this parameter setting.
[Response] Correct the parameter setting.
[Explanation]The directory name is too long.
[Response] Set a shorter directory name.
[Explanation]The "TARGET_FLAG" parameter is either incorrect or not set.
[Response] Correct the "TARGET_FLAG" parameter.
59
Copyright 2009 FUJITSU LIMITED