Using A Miter Gauge; Using The Starter Pin For Edge Forming Of Curves - Craftsman 171.61181 Owner's Information Manual

USING A MITER GAUGE
The miter gauge slot may be used with most
stationary table saw miter gauges that measure
3/4 in. wide x 3/8 in. deep°
NOTE: For ALL routing operations requiring the use of
the miter gauge with the fence, BE SURE to align the
fence using the scales on the top of the router table
before making any cuts. Miters can be cut by loosening
the knob on the protractor head, turning the protractor
head up to 60 ° in either direction and retightening the
protractor head knob.
Fig. 35
Miter gauge (not
USING THE STARTER PiN FOR EDGE FORMING OF CURVES
The starter pin (22) is used instead of the fence for
operations that involve routing curves in the workpieceo
It should be used only with bits that have pilot bearings.
Thread the starter pin into the threaded hole in the
mounting plate and tighten securely with a slotted
screwdriver (Fig. 36).
Attach the starter pin guard (23) to the mounting plate
by threading a #10-32 x 3/8 in. truss-head machine
screw (R) through the hole in the guard post and into
the threaded hole in the mounting plate° Align the guard
with the hole in the mounting plate so it is over the bit
and securely fasten the guard in place.
• Always use the starter pin guard when routing with the
starter pin.
When using the starter pin, the feed direction of the
workpiece is always right to left across the front of the
bit (Fig. 37).
Set the workpiece against the front of the starter pin
and swing it slowly into the bit.
While routing, make sure the workpiece is always in
contact with the bit's pilot bearing.
I AWARNING I
Use starter pin guard for this
I
LL [ type of operation.
Do not attempt
to rout very small workpieces. Keep fingers clear
of spinning bit.
Fig. 37
Starter
pin
DIRECTION
Pilot bearing bit
33