Adjusting the tear-off position
If the perforation is not aligned with the tear-off edge, adjust
the tear-off position by following the steps below:
1. Make sure the paper is in the tear-off position and the
light is on.
OFF
While holding down the
2.
button to adjust the
the page or press the
position to a higher position on the page. The printer
remembers the new tear-off position.
3. Tear off any printed pages.
When you begin printing, the printer automatically feeds the
4.
paper back to the loading position and begins printing.
(You can also manually feed the paper back to the loading
position by pressing the LOAD/EJECT or TEAR OFF button.)
Note:
The printer has a minimum and maximum tear-off position. If
you try to advance the loading position beyond these limits, the
printer beeps and the paper stops moving.
When the paper
printer beeps and paper feeding pauses briefly.
setting as a reference point when adjusting the tear-off position.
ALT button,
tear-off position to a lower position on
LF/FF button to adjust the
the factory-set tear-off position, the
reaches
press
the LOAD/EJECT
tear-off
Use the
factory
Using the Printer
TEAR
3-19