During Washing; Re-Selecting A Program; Add A Garment / Interrupting The Program; Canceling The Active Program - Bosch Nexxt 800 series Operating, Care And Installation Instructions Manual

During Washing
D Due to the highly engineered
suspension of this appliance, it
may experience a shudder or
shake when progressing from
lower to higher spin speeds.
This behavior is normal due to
shifting of the drum system and
should not cause concern.
Re-selecting a program
E::::l If the child lock is active, tempo-
rarily deactivate it (see page 20).
E::::l Turn the program selector to Off.
E::::l Turn the program selector to a
newly selected program.
The Start/Pause indicator light
flashes.
E::::l If the child lock is active,
deactivate again temporarily.
E::::l If required, change the settings.
(see Page 20).
E::::l Press the Start/Pause button.
The program starts.
Add a garment /
Interrupting the program
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the program at
any time.
D It is not recommended to add
laundry after the washing phase is
complete.
Without child lock
D You can add or reduce laundry as
long as the Start/Pause indicator
light flashes (red).
E::::l Press the Start/Pause button.
The following displays are
indicated in succession:
"Pause",
"Door can be opened".
E::::l Open the door.
E::::l Add/remove the laundry.
E::::l Close the door.
E::::l Press the Start/Pause button.
The program continues.
The indicator light is lit (red).
%
%
When the Start/Pause indicator
light is lit (red), the program can be
interrupted, however the door
cannot be opened for safety
reasons (water level, temperature
or drum speed too high).
If the speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
"Pause" mode when the drum is at
a standstill.
Child lock activated
D Refer to the Child Lock section,
(see page 20).
Canceling the active
program
If you would like to terminate a program
and remove the laundry:
E::::l Press the Start/Pause button
E::::l If Child Lock is active, it is
necessary to press and hold down
the Start/Pause button for five
seconds
%
If the load is too wet, turn the
program selector to Drain/Spin.
If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
If the program is terminated by
switching off the appliance, the
door may remain locked.
After Washing
The Start/Pause indicator light goes
out.
Display field: "Remove laundry".
Turn the program selector to Off.
Close the taps.
E::::l Remove the laundry.
Occasionally check for any foreign
objects (e.g. coins, paper clips)
between the drum and rubber seal
-To avoid risk of rust!
DAfter washing, leave the loading
door ajar to allow the inside of
the washing machine to dry.
E::::l Open the door.
21