Dimensions; Installation Area - Bosch Nexxt 800 series Operating, Care And Installation Instructions Manual

2.Wrench forleveling.
3.Clamp fordrain hose.
Onthe backofthe washer:
hotandcoldwaterconnections
power cordwithlabel w arning t o
remove t ransportation bolts
twoAQUASTOP ®hoses (remove
hoses fromclipsonbackof
washer f orinstallation)
Power _rd hot water _Jd water
AQUASTOP _}hoses
Useful tools
The following tools are helpful:
1. Flat head screwdriver.
2. Socket wrench (1/2" / 13 mm).
3. Closed wrench (1/2" / 13 mm).
4. Bubble Level.
2
3
Dimensions
C
a = 27.0 inches (686 mm)
b = 30.7 inches (780 mm)
c = 37.0 inches (940 mm)
d = 16.0 inches (407 mm)
Door opening angle 180 °
Approx. weight = 220 Ibs (1O0 kg)
Installation area
Never ground the washer to plastic
plumbing lines, gas lines or hot
water pipes.
This appliance must be installed on
a solid floor and well leveled due to
the higher spin speeds available. If
installing the machine on a wood
floor over a basement or on a
second floor, the floor may need to
be reinforced. Sound, vibration, and
risk of "walking" will be affected
depending on the structure and
stability of the floor surface where it
is installed.
If the washing machine is to be installed
on a weak wood floor consider the
following:
CI Soft floor surfaces, such as
carpets or surfaces with foam
backing, are not suitable. If
possible, place the washing
machine in a corner of the room.
CI Screw a water resistant wooden
board (at least 3/4" thick) to the
floor.
CI
Secure the feet of the washing
machine with holding brackets.
Order the holding brackets (set)
from Bosch Customer Service
(WMZ 2200).
CI Units are not designed to be
stacked.
CI Units are not designed for under
counter installation
Pedestal Mounting Kit
8 inch pedestal accessory number
WTZ 1295 for solid white color
WTZ 1295S for solid silver color
WTZ 1295P for duo tone silver/white
15 inch pedestal accessory number
WTZ 1500 for solid white color
WTZ 1500S for solid silver color
WTZ 15000 for duo tone
champagne/white
WTZ 1500P for duo tone silver/white
If mounting the washer on the pedestal
follow the instructions supplied with the
pedestal.
D Install pedestal prior to
removing transport bolts.
Closet
If installing the washer in a closet,
observe the minimum distances
according to the following table:
Minimum Installation Clearances
Closet
Sides 1/4" (6 mm)
Top 12" (305 mm)
Rear 25" (64 mm)
Front 1/4" (6 mm)
Ventilation:
Top: 48 sq. in (310 sq. cm),
Bottom: 24 sq. in (155 sq. cm)
Checklistfor Page
Installation
completelyremove4 shippingbolts 8
and movethe washerintoplace
connectthe watersupply linesand 9
drain pipe
connectthe electrical p ower 10
slidethe washerinto its final location 10
levelthe washeras 10was possible 10
beforefirst use, run a cleaningcycle 13