To Change Measuring Reference Point; To Change The Units; To Take Measurements; Clear Function - Craftsman 320.48298 Product Manual

To change measuring reference point
_, Indicates that the measurement is computed from the position of the rear of the tool.
f_'Indicates that the measurement is computed from the position of the front of the tool.
After powering off, the reference point will automatically default back to rear.
To change the units
Press the M\Ft key to change the units among 1/16 in. increments, decimal units of
feet, meter, and millimeter after taking measurements, as shown below.
Setting Distance Area Volume
1/16 in feet & 1/16inch feet 2 feet 3
ft feet (decimal) feet 2 feet 3
m meters
m 2 m 3
mm millimeters
m 2 m 3
To take measurements
NOTE: The laser wil! switch off after 20 seconds of inactivity, If a measurement has
not been made within the previous 20 seconds, push MEASURE again to turn on
the laser.
A
,_k WARNING: Do not point the la-
ser dot at persons or animals and do
not stare into the laser beam or view
directly with optical instruments.
Clear function
Push the Clear button to erase the
current measurement and display
the previous measurement.
Fig. 4
Single distance measurement
.
Press the MEASURE key to turn
on the laser; the laser indicator
will blink from bottom to top
(see Fig. 4 & 5).
,
Aim the laser at the target you
want to measure; the integrated
vial can help you level your tool,
3. Press the MEASURE key again
to take a measuremenL
Fig. 5
I
I
48298 ManuaLRevised 0743225 Page 9