Sharp MD-DR470H Operation Manual page 21

" Adding tracks to an existing group
1
Press the REC button.
Recording is paused.
2
Hold down the GROUP button for 2 seconds
or more so that "GR" is lit.
3
Press the MENU button.
The unit enters the menu select mode.
4
Select "GrSELECT" by
pressing the or but-
ton and press the MENU
button.
5
Press the or button repeatedly to se-
lect the group you want to add tracks to.
NEW GROUP
To create a new group.
GR01, GR02, GR03...
To add tracks to an existing group. (If the group name
has been recorded, the name will be displayed in-
stead of "GR01".)
Non GROUP
To record tracks as non-group.
6
Press the MENU button.
7
Start recording.
MD-DR470H(E) TINSE0513AWZZ
MD-DR470H(E) TINSE0513AWZZ
About the TOC
After any recording or editing function, "TOC" (Table Of
Contents) is displayed. To finalise the recording or editing
function, turn the power off. During this process, "TOC"
will flash and "TOC EDIT" will be displayed. During any
recording or editing function, the MiniDisc unit lid is
locked, and the MiniDisc cannot be removed until the
process is finalised.
Warning:
If the power is removed (Battery/AC adaptor) whilst
"TOC" is displayed, the MiniDisc unit lid will remain
locked until the battery/main power is restored and the
unit is turned on. Your new recordings or edited changes
will be lost and your MiniDisc may become unusable.
Caution:
Whilst "TOC" or "TOC EDIT" is displayed, follow the
instructions below.
- Do not jerk or bump the unit.
- Do not unplug the AC adaptor.
- Do not remove the rechargeable battery or an alka-
line battery.
- Do not subject the unit to shock.
Otherwise, tracks may not be recorded properly.
03/3/25 MD_DR470H_UK_3.fm
4
MD-DR470H
9
8
7
6 6
5 5
4 4
3 3
2 2
1 1
21