Sharp MD-DR470H Operation Manual page 41

! Sound-actuated recording (Mic
Synchronised recording)
The unit automatically pauses when the microphone
does not pick up any sound for 3 seconds or more.
(Pause function does not work for approximately 10 sec-
onds after a recording starts.) When the microphone
picks up sound again, recording starts automatically.
Cancel the setting for trace-back recording.
1
Press the REC button.
Recording is paused.
2
To perform group recording, hold down the
GROUP button for 2 seconds or more so
that "GR" is lit.
When group recording is not performed, hold down
the GROUP button for 2 seconds or more so that
"GR" goes out.
3
Press the or button to adjust the re-
cording level (page 20).
4
Press the MENU button.
The unit enters the menu select mode.
5
Select "REC MODE" by pressing the
button and press the MENU button.
6
Select the recording mode (step 3, page 35)
and press the MENU button.
MD-DR470H(E) TINSE0513AWZZ
7
Press the MENU button.
The unit enters the menu select mode.
8
Select "SYNC REC" by
pressing the or but-
ton and press the MENU
button.
9
Select the recording start
level by pressing the
or button and press
the MENU button.
MIC SYNC H (High):
Recording starts when the unit detects -24 dB or
more (the unit can start recording from quiet sounds).
MIC SYNC L (Low):
Recording starts when the unit detects -12 dB or
more.
" SYNC will flash.
" To cancel the operation, press the
10
When a sound, such as person speaking, is
picked up by the microphone, recording will
begin automatically.
or
Notes:
" Synchronised recording cannot be set with trace-
back recording. Cancel trace-back recording (page
38).
" If the unit starts recording from low unwanted noises
too often, set the microphone input to "MIC SYNC L
(Low)".
03/3/25
MD-DR470H
button.
41
MD_DR470H_UK_5.fm
9
8
7
6 6
5 5
4 4
3 3
2 2
1 1