Table of Contents
Advertisement
Full exit tray
A message appears in the display prompting you to remove paper from the exit tray.
G
The mode can be changed. However, if the exit tray became full during a copy job, the mode can-
not be changed. In this case, you can press the CLEAR ALL key or the CLEAR key to cancel the
job and then change the mode.
G
In fax mode or print mode, operation is the same as "Out of paper".
Notes
G
When the error is cleared, the job that was in progress before the error occurred resumes.
G
If the exit tray becomes full during a print job, the job cannot be canceled. Remove the
paper from the exit tray.
Toner replenishment mode
If toner replenishment mode activates during a copy job, fax job, or print job, "Toner replenishment
in progress" will appear in the display. You must wait until replenishment is completed.
Other errors
Errors with the same operation as "Out of paper"
G
No tray with selected paper size
A message appears informing you that there is no tray with the selected paper size.
G
No paper in bypass tray
A message appears in the display prompting you to load the selected size of paper in the
bypass tray.
G
Tray not attached
This occurs when the selected tray is not attached or is pulled out.
G
Paper tray lift-up
A message appears telling you to check the paper in the tray or that tray trouble has
occurred.
Errors with the same operation as "Out of toner"
G
TD cartridge not installed
The display shows "Install a TD cartridge" or "Check the TD cartridge".
G
Toner cartridge not installed
The display shows "Check the toner cartridge".
G
Maintenance required (machine stops at set time)
The display shows "Maintenance required. Call for service." If this occurs during a job, the
machine will not stop until the job is finished.
Operation when an error occurs
13
Advertisement
Table of Contents
