KEYBOARD FUNCTION
(Fig, 2)
Please see the Operation
section of this manual for
information
about the following
functions and computations..
1.. Read/Con key -turns on the
laser, takes measurements,
activates the continuous
measurement.
2., Clear key- clears the
measurements,
reverts
to single distance
measurement
mode,,
3. Max/Min key- activates the Maximum or Minimum measuring
mode..
4_ Plus/Minus
key - for addition or subtraction
of measurements..
5
Mode key- changes the measuring mode among area, volume, single
Pythagorean Theorem, double Pythagorean
Theorem, and single distance
measurement
mode
6,,
7
Measuring reference point _ Switches the measuring reference among: the
rear of the toot, the position of the tripod screw, the front of the tool, and the
positioning
pin..
Unit conversion key- change units: decimal units of feet, t/16-in,
increments,
decimal units of inches, 1/16-in, increments of inches, meters, and millimeters,,
Power key- turns on/off the tool..
LCD DISPLAY
Full battery indicator
Empty battery indicator
_
indicates that the measurement
is taken from the positioning
pin..
_!
Indicates that the measurement
is taken from the bottom of the too!..
_J
Indicates that the measurement is taken from the position of the tripod screw.
_'
Indicates that the measurement
is taken from the front of the tool
Laser beam indicator
Single distance measurement
_ZZArea
measurement
Volume measurement
48277
Manual_Revised_09.0211
Page 7