Craftsman 172.11810 Operator's Manual page 17

..... l
Ak CAUTION:
When placing battery pack in the tool, be sure raised rib on
battery pack aligns with the bottom of the drill and latches Into place properly.
Improper Installation of the battery pack can cause damage to internal
components.
WARNING:
Cordless Battery Tools are always in operating condition when
the battery pack Is installed in the tool.Therefore the Forward / Reverse Selector
Switch with Power Lock.Off should always be in the center position, locking the
power off, when the tool is not In use or when you are carrying it at your side.
TRIGGER SWITCH (Fig. 6, 6a and 6b)
To turn the drill ON, push the Forward/Reverse So{actor Switch with Power Lock-Off to lhe
FORWARD or REVERSE location (sea arrow direction embossed on swilch), and depress
the triggerswitch.To turn the drt!lOFF, release the trigger swttch_
FORWARD REVERSE
VARIABLE SPEED (Fig. 6b)
The variablespeed triggerswitchdelivershigher speed and torque with increased
pressureon the triggerswitch end lower speed and torque with decreased pressure on
the triggerswitch,
1
NOTE:You might hear a whistling or ringing noise from the trigger switch when |
operating at low speeds° Do not be concerned; this ts e normal part of the
/
switch functiorto
ELECTRIC BRAKE
To slop the drill/driver, release the trigger switch and lhe eiectric brake will stop the chuck
instantly,,
NOTE: The drill/driver will not operate unless the Forward / Reverse Selector
Switch with Power Lock"off is pushed fully to the left (forward) or to the rtght
(reverse).
Avoid running the drill/driver at low speeds for extended periods of time, Running al low
speeds under constant usage may cause the drt!_drtver to become overheated., ff this
occurs, cool ihe drill/driver by running it without a Iced and at futi speed.
17
7-11-07