Hitachi AX-M20EBS Instruction Manual page 16

Table of Contents

Advertisement

RESET
If operations or the display malfunctions:
Many functions of this unit are controlled by microprocessors which are vulnerable to
electromagnetic interference. To restore your systems functions in such an event, make
sure the unit in standby mode and then press the reset switch. You will also have to preset
your radio stations again because pressing the reset switch clears the preset stations.
Rear view
TUNER SECTION
TUNER AERIALS
• For FM, connect the provided FM feeder antenna (see page 7).
• For MW, adjust the position of AM loop antenna (see page 7).
A. STEREO/MONO button (using the remote control unit)
- Auto mode:
When listening to an FM stereo broadcast, set the unit to this mode by pressing the ST/
MONO button. The STEREO indicator lights up when the FM stereo broadcast is received.
- Mono mode:
When the FM stereo reception is weak or noisy, set the unit to MONO MODE by pressing
the ST/MONO button.
- Seek tuning:
Press and hold the UP or DOWN button for one second or more. The unit enters the seek
tuning mode to automatically tune in the nearest station, so the broadcast can be heard.
- Manual tuning:
Each time the UP or DOWN button is pressed, the unit steps through the current frequency
band.
Note:
• When seek tuning to the required station is not possible because the broadcast signal is
too weak, press the UP or DOWN button momentarily to perform manual tuning.
• When the unit is set to STANDBY, or another mode (CD or AUX) is selected, the last
tuned frequency is stored in memory. When the power is switched on again and BAND
button is pressed, the same station will be turned to.
B. Auto preset tuning (using the remote control unit)
This will automatically store any broadcasting stations with strong signals into the memory
(Max. 10 for FM and 10 for MW)
• Press the AUTO PRESET button for more than 2 seconds. The frequencies of stations'
broadcasting signals can be stored in memory automatically in the order of increasing
frequency.
R
L
R
L
Press RESET switch inside
the unit with a cocktail stick.
Do not use a metal stick.
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ax-m20e

Table of Contents