Table of Contents
Advertisement
C. Presetting stations (using the remote control unit)
A total of 20 FM or MW stations can be memorized.
Notes:
• The previous stored station is erased when a new station is stored, because the
new station's frequency replaces the previous frequency in memory.
• When listening to a MW broadcast, noise may be heard if the remote control unit is
used.
• All preset stations will be erased when the power cord is disconnected or a power
failure occurs. In such cases, store the stations again.
D. If you hear beat noise while recording from an MW station, flip the beat cut switch to
reduce the noise.
E. Frequency step of MW band
To tune to your local MW station, you can select either 9 kHz or 10 kHz as the frequency
step. By default, the factory setting for the unit's step is 9 kHz.
To switch to the required frequency step:
1) Make sure the unit is in TUNER MODE and the band set to MW.
2) To select 9 kHz frequency step - press and hold the BAND button while pressing
the ¡/¢ button.
3) To select 10 kHz frequency step - press and hold the BAND button while pressing
the 4/1 button.
The frequency step that you have set will be in effect until either step 2 or 3 is performed
again.
F. RDS Button (using the remote control unit)
Use this button to automatically tune to stations using the radio data system. There
are program type identification (PTY), clock time (CT) and radio text (RT) functions.
DISPLAY
• RDS (Radio Data System) When the RDS button is pressed, the system searches for
a station and automatically tunes it in. The "RDS" indicator lights up and the station's
name is displayed on the display.
• PTY (Program Type) This indicator lights up when the type of RDS program is specified.
• RT (Radio Text) This lights when in RT mode and the RT message is displayed.
REMOTE CONTROL
CD
0
10 +
REPEAT
PROGRAM/
ST/MONO RANDOM
AUTO PRESET
TAPE
CD/TUNING
REW.
F.FWD
CT
PTY
PANEL
RDS
X-BASS
PRESET EQ
-
+
VOLUME
REMOTE CONTROLLER
RB-AXM20
HITACHI
CT button
Use this to correct the time of the clock on the AX-M20. Press
this button when the time service of an RDS station is
received correctly. "CT ON" is displayed for 2 seconds and
the AX-M20's clock is corrected. Press the CT button twice,
and "CT OFF" is displayed.
❈ The clock can be adjusted manually in "CT OFF" mode.
RDS button
Automatically tunes to stations using the radio data system.
17
Advertisement
Table of Contents
