Sharp Display Manager Operation Manual page 25

3. When connecting normally, the display will be as follows.
(The screen may be slightly different depending on the OS type).
<Example> when the IP address connected to is "192.168.150.2"
4. When a command cannot be sent, "Request time out" will be displayed.
Check the network setting again.
If communication can still not be established properly, contact your network
administrator.
5. To return to the Windows
• When the device cannot be connected, even though the "PING" command is checked:
1. When there is a setting for an "Accept IP Address" in the device, set the IP address
of the PC to be connected.
2. When a security software is installed on the PC, or when a fire wall has been set
up for the network system, connection may not be possible.
Consult the system administrator in order to enable use of the UDP/TCP port set
as the search port, and TCP port set as the data port.
3. When neither of the above two items applies, change the settings for either the
search port or the data port (page 19). When the setting for the search port for the
Software is changed, the settings for the search port on the device must also be
changed accordingly.
25
® screen, enter "exit" and then press the "Enter" key.