Touch Pad Models - GE AGM14 Owner's Manual And Installation Instructions

Aboutthe controlsontheair conditioner odels with touchpads.
Features and appearance will varg.
Co01 On
_n on
Energy
Saver 0[/
0
0
0
O
0
0
Air ConditionerControls
RemoteControl
Controls
o ON/OFFPad
Turns air conditioner on and otE
k Display
F Shov_ the set temperature or time remaining
on timel:
O MODE
Use to set the air conditioner
to COOL or
/AN mode.
Gk Increase •/Decrease • Pads
r Use to set temperature
when in COOL mode.
O FANPad
Use to set the fan speed to LOW(F1),MED(F2)
or HIGH(F3).
OENERGYSAVER-Controls
the fan.
(on some models)
ON-The thn and compressor cycle on and
off. This results in wider variations of room
temperature and humidity. Normally" used
when the room is unoccupied. Note: The fan
will continue to run for a short time after the
compressor cycles of_
OFF-The fan runs all the time, while dm
compressor cycles on and off.
This feature must be set at OFFin order to use
the tan settings (on the mode control).
Note:On some models,the ENERGY SAVER
feature cannot be set on the air conditioner.
It mustbe set using the remote control.
O CIRCULAIRE(on some models)
For continuous side-to-side air circulation
(cool settings only'), set the Circulaire switch
to ON.
For fixed side-to-side air direction, turn ON
until the desired air direction is obvained,
then turn it OFI_
O TIMER Pad
ON-When the air conditioner
is of[; it can be
set to automatically come on in 1 to 12 hours
at its previous setting. Each touch will set the
timer in hours.
OFF-When
the air conditioner is on, it can be
set to automatically turn offin 1 m 12 hours.
Each touch will set the timer in hours, zM'ter
tim timer has been on for 30 miimtes, the
temperature will automaticAly rise 2°E and
after another 30 minutes, it will m]mmatically
rise 2°F again. _12qemmperature will then stay"
the same until the timer goes OFF.
TOcancel the timer, press the TIMER pad until
the display" time disappears.
o Remote Control Signal Receiver
4
Remote Control
% To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
% The remora control signal has a range of up
to 21 feet.
_ Make sure nothing is between the air
conditioner and the remote control
that could block the signal.
_ Make sure batmries are fresh mad installed
correctly as indicated on the remote control.