Control Knobs - GE PGP989 Owner's Manual & Installation Instructions

Gas downdraft cooktop
Table of Contents

Advertisement

Available languages

Available languages

ge.com
i l
!
The control Mobs may be removed
Foreasier cleaning.
Control Knobs
Thecontrol knobs nag be removed for
easier cleaning.
Hake sure the knobs are in the OFF
positions and pull them straight off the
stems for cleaning.
To clean the knobs, place them in a
dishwasher or wash with soap and water.
Rinsewith clean water. Hake sure the
insides of the knobs are dry before
replacing.
Replace the knobs in the OFF position
to ensure proper placement.
Stainless Steel Surfaces (onsomemodels)
Do not use a steel wool pad; it will
scratch the surface.
To clean the stainless steel surface,
use warm sudsy water or a stainless steel
cleaner or polish. Always wipe the surface
in the direction of the grain. Follow the
cleaner instructions for cleaning the
stainless steel surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call
our toll-free number:
National Parts Center
1.800.626.2002
ge.com
Cleaning the glass cooktop.
\
/
Clean your cooktop after
each spill. Use CERAMA
BRYTE ® Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLYuse CERAHABRYTE ¢ Ceramic
Cooktop Cleaner on the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
%
Before using the cooktop for the
first time, clean it with CERAMA
BRYTE ® Ceramic Cooktop Cleaner.
This helps protect the top and makes
clean-up easier.
[_[] Daily use of CERAMA BRYTE ®Ceramic
Cooktop Cleaner will help keep the
cooktop looking new.
[_
Removethe burner grates, vent grille
and vent grille gasket.
[]
%
%
Shakethe cleaning cream well. Apply
a few drops of CERAMABRYTE ®
Ceramic Cooktop Cleaner directly to
the cooktop.
Use a paper towel or CERAMA BRYTE ®
Cleaning Pad for Ceramic Cooktops to
clean the entire cooktop surface.
Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that you DO
NOT heat the cooktop until it has been
cleaned thoroughly.
Use a CERAMA BRYTE ® Cleaning
Pad for Ceramic
Coot<tops or a
Scotch-Brite
® Multi-Purpose
No
Scratch
blue scrub pad.
Burned-On
Residue
WARNING: DAMAGEto _lour glass surface
F4]
may occur if you use scrub pads other
than the pod included with gout cooktop.
%
%
[]
%
Allow the cooktop to cool.
Remove the burner grates, vent
grille and vent grille gasket. Spread
a few drops of CERAMA BRYTE ®
Ceramic Cooktop Cleanerto the
entire burned residue area.
Using the included CERAMABRYTE ®
Cleaning Pad for Ceramic Cooktops,
rub the residue area, applying
pressure as needed.
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAHA
BRYTE ®Ceramic Cooktop Cleaner
and a paper towel.
13

Advertisement

Chapters

Table of Contents
loading

Table of Contents