Installation Instructions - GE PGP989 Owner's Manual & Installation Instructions

Installation Instructions
UNPACKING YOUR COOKTOP
PARTS INCLUDED {PACKED BELOW THE COOKTOP)
• Blower assembly • Vent grille gasket • Burner caps
• Blower plenum • Cleaning cream (1 small, 2 medium, 1 large)
• (/4)Nuts (10-32 keps - nuts with • Scrub sponge or scraper • Gas pressure regulator &
lock washers attached) (on some models) LP Conversion Instructions
• (9) Sheet metal screws • Burner grates • Attached 120-volt grounded
(8-18 x 3/8") • Burner heads plug cord
• Foam gasket tape (9-ft. roll) (1 small (A), 2 medium (B), • Reflective tape
• Vent grille 1 large (C))
• Vent filter
Check to be sure that oil packing materials
and tape have been removed. This will include
tape on control knobs (if applicable), adhesive
tape, wire ties, cardboard and protective
plastic. Failure to remove these materials could
result in damage to the appliance once the
appliance has been turned on and surfaces
have heated.
Reflective Tape
Cleaning Cream
Sheet Metal Screws (9)
(8-18 x 3/8")
BurnerGrate(2)
-A CAUTION:
GLASS IS FRAGILE
DO NOT BUMP EDGE
OF GLASS DURING
INSTALLATION
Regulat°rBurner C _i_i
"
BurnerCapandBurnerHead
Blower Assembly and (4) Mounting
Nuts (10-32 keps - nuts with lock
washers attached)
ii '_i'
Foam GasketTape
Vent Grille Gasket
16
Blower Plenum Vent Filter