Table of Contents
Advertisement
This function e nables youtoset a recording length
simplyby pressing theREC/OTR buttonon the
TV/VCR.
Make sure ...
• TV/VCR power must be turned on.
• Insert a cassette tape with its erase prevention tab in
place. (If necessary., rewind or fast forward the tape
to the point at which you want to begin recording.)
NOTES:
• This function CANNOT be done from the remote
control.
• Recording starts immediately when the REC/OTR
button is pressed.
• When the REC/OTR button is pressed 18 times, the
TV!VCR returns to the normal recording mode.
• To stop the OTR operation, press the STOP button
on the TV/VCR or on the remote control.
• To show the remaining time, press the DISPLAY
button on the remote control so that "OTR" appears
on the TV screen. (It will show up momentarily then
disappear.)
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode maxinmm record-
ing time, assuming the tape is started at the begin-
ning, is 8 hours using T-160 (or 6 hours using T- 120).
• If the tape runs out before the end time, the TV/VCR
will switch to the Stop mode immediately, eject the
tape and turn power off.
Select the channel to be recorded
Press the number buttons on the remote control or the
CHANNEL • or • button.
Press the REC/OTR button on
the TV/VCR as many times as
needed. The recording length will be detemfined by' the
number of times you press the REC/OTR button.
Each additional push will increase the recording time by
30 minutes. It is set up to 8 hours.
Push(es)
1 push
2 pushes
3 pushes
+
17 pushes
Display
0:30
1:00
8:00
Recording length
(normal recording )
30 minutes
60 minutes
+
480 minutes
You can make copies of video tapes made by friends or
relatives for your enjoyment.
WARNING:
Unauthorized.
recordings
of
copyrighted vMeo tapes may be an
iinfringemen!
of copyright laws.
Connect your TV/VCR
and a source (playing)
VCR
using the following diagram.
o
AudioNideo
adapter
cord
(not supplied)
[The TVNCR]
[Ex: Source (Playing) VCR]
VIDEO
_@ @
out
1
Insert a pre-recorded
video cassette into the source
(plavino), _ VCR
Insert a blank video cassette, or one: you want to record
over, into the TV/VCR's cassette compartment.
3
Press the SPEED button to select the desired recording
speed (StVLP/SLP).
4
-L
Press the CHANNEL • or • button until "AUX"
appears on the screen.
3
Press the RECORD button on the TV/VCR.
6
Begin playback of the tape in the source (playing) VCR.
N@TE: For best results
during
dubbing,
use the
TV/VCR's front panel controls whenever
possible. The remote conlrol might affect the
source (playing) VCR's playback operation.
- 25 -
Advertisement
Table of Contents
