The Zip Code And Latitude & Longitude Screens; Alignment Result Screen; Connecting The Satellite Dish - Hitachi DSS SYSTEM Owner's Manual

HITACHI DIGITAL SATELLITE S YSTEM OWNER'S MANUAL
The ZIP CODE and LATITUDE & LONGITUDE Screens
The ZIP CODE screen The LATITUDE & LONGITUDE screen
You _ now see one of the above screens. Enter your location. If you are using the remote
control, press the _ key, followed by the five appropriate digits. From the remote control or
receiver front panel you can also use the A or V keys to increase or decrease the highlighted digit
value, and the > key to advance to the next digit. Use the < key to back up to correct any
mistakes. When you are finished, the highlight should be on the button labeled OK Press
to continue.
ALIGNMENT RESULT Screen
The ALIGNMENT RESULT will be disphying the proper elevation and azimuth for pointing
the dish calculated from the location you entered. Elevation is the
up and down positioning, fmailar to nodding your head "yes."
Azimuth is the left to right positioning, _mai!ar to shaking your head
"no." You should take a moment to write down the elevation and
azimuth numbers.
ELEVATION: AZIMUTH:
The values displayed are fairly accurate; however some fine tuning
may be necessary. Use these values when choosing a mounfng
location for your satellite dish, remembering that you will need an
unobstructed view in that direction.
The ALIGNMENT RESULT screen
Before proceeding, your DSS antenna should be installed. If this has not already been done,
please see the Satel_te Antenna Insta&#on Guide for instructions, or contact a professional installer.
From this point forward in this document we will assume that your dish has been mounted, the
cable has been run from the dish to your receivers location.
Connecting the Satellite Dish
You must connect the satellite antenna cable to receive a signal. You should urrplugyourDSS receiver
from the power outletprior to making this connection. O nce the antenna has
been mounted and the DSS cable has been run from the antenna to
the receiver you are ready to monitor the signal strength while
@
• SATELLITE [N
Connecting the satellite antenna cable
Page16