Your Hitachi Receiver's Setup Menu; Assistance; New Access Card; Vcr Setup - Hitachi DSS SYSTEM Owner's Manual

YOUR HITACHI RECEIVER'S SETUP MENU
Assistance
The ASSISTANCE screen should be your first stop when you need help or have a question.
Think of this screen as an on-line quick reference manual The first
page of this screen is an index to the areas of assistance that are
offered. Some of the screens included are important phone
numbers, programming your remote control, solving oammon
problems, controlling a VCR, and more.
The ASSISTANCE screen
Check this screen to see the range of assistance that is offered. If
that doesn't help, refer to this manual
New Access Card
The NEW ACCESS CARD screen provides a process by which the service providers can
distribute new access cards. Should you be issued a new card, you
will need to activate it_ Follow the on-screen instructions carefully to
initialize it. Once the process has begun, your old access card will no
longer allow viewing. Follow the on-screen instructions carefully.
You should not interrupt the process once it has started. An
interruption could cause both the old and the new card to become
invalid. When the process has completed your new access card w4al
be usable, while the old card will no longer be valid.
The NEW ACCESS CARD screen
VCR Setup
The VCR SETUP screen
The VCR SETUP screen is used to set your Hitachi digital satellite receiver to control your VCR.
To determine the code necessary, first choose Code Laokup. You can
page through the various brands of VCRs until you have found your
particular VCR type. Next, write down each number associated with
your VCR brand. When you press the _ key you will return
to the VCR Setup screen. Now choose Set Code.You can now enter
the first code in the list that you noted. Insert a blank rape in your
VCIL With the VCR turned on, choose Test and try bothRecord and
Stop. If both of these tests are successful, your DSS receiver is now
ready to orchestrate unattended recording. If either the Record or
Stop test do not function, use the Set Code to try additional codes that
you noted for your VCR until the testing proves successful. You
should repeat the test through several Record,Stop cycles to confirm
that a reliable code and cable placement is being used.
Page 41